5.Manually rotate the needle of the
automatic shut- off system to the
pressure you want.
WARNING!
NEVER overfill the maximum
pressure of your cylinder and
airgun. The maximum pressure for
this compressor is 300bar
(30Mpa/4500PSI).
6.Press the Compressor button on
the top of the compressor to start
the cooling fan.
ATTENTION! The fan must be
running when the compressor is
working.
7.Close the air bleed valve on the
front of the main unit by turning it
clockwise. It need only be finger
tight.
8.Finally, press the POWER button
on the top of the main unit. The
compressor unit will audibly start
up and the charging process will
begin.
To Next Page
Loading...
