Using DC 12V Car Battery Power
9.Insure the car engine is
running.Connect the supplied DC
power cable to the right side of the
12v socket.
Connect the red clip at the other
end of this cable to the positive (+)
terminal of the car’s12-volt
battery.Then connect the black clip
to the battery’s negative (-)
terminal.
The rest operation is same as step
6 on page 5
NOTE:
If the working temperature exceeds 80 degrees Celsius, the compressor
MUST be manually switched off, you can press the POWER button to
make the compressor stop working. Keep the cooling fan left running.
Restart the compressor function once the compressor has cooled down.
The compressor will be auto shut-off every 30 minutes to prevent
overload and overheat.You can restart the compressor by pressing the
POWER button again if air filling not finished.
Routine Maintenance
Note: we suggest you can do maintenance by changing o-rings and
clearing dirt every 50 pieces 500cc bottle filling or cumulative working 20
hours.
Insure all power is disconnected before maintenance !
To Next Page
Loading...
