This product is of protection class III.
FCC statement:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1)This device may not cause
harmful interference, and (2)this device must accept any
interference received, including interference that may cause
undesired operation.
Disposal information:
This product is subject to the provision of European Directive
2012/19/EC. The symbol showing a wheelie bin crossed through
indicates that the product requires separate refuse collection in the
European Union. This applies to the product and all accessories
marked with this symbol. Products marked as such may not be
discarded with normal domestic waste, but must be taken to a
collection point for recycling electrical and electronic devices
WARNING: Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
1. The machine tool should be used by experienced personnel. If you are
not familiar with the operation process of the lathe, do not use the
machine tool at will. Use the instructions before operating.
2. Before starting the machine tool, the safety cover should be in the
correct position.
3. Before starting the machine tool, please check whether the tool rest
wrench and chuck key are removed.
4. Prevent the machine from starting accidentally. Turn off the motor
power before clamping the workpiece or tool.
5. Don't force cut. Cutting according to the set cutting speed, cutting
depth and feed speed.
6. Use the right tools. Use the correct tool or workpiece for machining.
To Next Page
Loading...
