Note: The above data are
measured manually, and
there will be a little error.
Please refer to the real
object.
Matters needing attention
Before use, check the state of the special shock absorber tool, confirm that the
fixed connection between the special tool and the bracket is normal, and confirm
that the fastening nut of the spring clamp is tightened.
Spring compressors need to be placed parallel on both sides of the spring.
After the tool is pressed against the spring, it will receive a relatively large tensile
force. The greater the compression, the greater the tensile force.
When the tool receives a large tensile force, it is not possible to use external
machinery, such as an air gun or an electric wrench, to tighten the screw. At this
time, it is necessary to use a manual socket wrench to compress the spring on
both sides.
To Next Page
Loading...
