Install the protection ring on the compression
assembly and secure with screws.
2. Remove the shock absorber mounting nut,
confirm that the spring and clamp are firm, and use the shock absorber nut
removal special tool to remove the nut.
3. Install the shock absorber, use the shock absorber nut to remove the special
tool mounting nut, and confirm that the nut is tight. Loosen the clamp gradually
until the spring is separated from the clamp, and correct the installation position of
the shock absorber, thrust bearing, buffer block, etc.
4. The required specification is a 19mm or 3/4" sleeve.
Turning the hexagon nut hook will
compress the spring.
Manual operation available.
To Next Page
Loading...
