Vex Robotics Clawbot - Page 20

Clawbot 1.0 • 20
© 2013 Carnegie Mellon Robotics Academy / For use with VEX
®
Robotics Systems
RO
O
R
BOT
T
O
B
C
C
C
CLAWBOT BUILDING INSTRUCTIONS
Attaching the Limit Switch (continued)
6
Building Tip - Using Pop Rivets
x2
x1
Recover the bearing
block you saved
earlier from the
potentiometer build.
Place it underneath
the claw as shown
below. This will help
the claw activate
the limit switch
100% of the time