What to do if VIAIR 400P airflow is low or cannot pump to higher pressures?
If your VIAIR Air Compressor's airflow is lower than normal or it cannot pump to higher pressures, it could be due to a worn piston ring or inlet valve. It is suggested to service or replace the compressor.
What to do if my VIAIR 400P will not run?
If your VIAIR Air Compressor isn't running, there could be a few reasons. First, ensure the compressor switch is in the ON position. If that's not the issue, check the fuse and replace it if it's blown, making sure to disconnect the compressor from the power source first and using the correct amperage fuse (refer to the Specifications section for correct fuse amperage). Lastly, the motor might have overheated; if so, let the compressor cool off for about 30 minutes to allow the thermal overload switch to reset.
Why does the thermal overload protector on my VIAIR Air Compressor keep cutting out?
If the thermal overload protector on your VIAIR Air Compressor is repeatedly cutting out, it could be due to a lack of proper ventilation or a high ambient temperature. Try moving the compressor to a well-ventilated area or an area with a lower ambient temperature. Alternatively, the compressor valves may have failed, requiring you to replace the compressor.
How to fix excessive knocking or rattling in VIAIR 400P Air Compressor?
Excessive knocking or rattling in your VIAIR Air Compressor can be caused by a worn bearing on the eccentric or motor shaft, or a worn cylinder or piston ring. In either case, you should service or replace the compressor.
Covers precautions against electrical shock, electrocution, and injury prevention during operation.
Details the procedures for inflating and deflating tires using the included tire gun kit.
Explains the function and usage of the pressure gauge on the tire inflation gun.
Provides guidance on safe driving with aired-down tires and handling hot hoses/fittings.
Offers advice on compressor restarts, usage recommendations, and basic maintenance.
General| Max Working Pressure | 150 PSI |
|---|---|
| Duty Cycle | 33% @ 100 PSI |
| Max Amp Draw | 30 Amps |
| Type | Portable |
| Amperage Draw | 30 Amps |
| Power Source | 12V |
| Hose Length | 25 ft |
| Air Flow | 2.3 CFM |
To Next Page
