Falcon Service Manual
___________________________________
8
! Replace wire ties and reroute wires as they were initially found. Do not leave loose hardware or
tools inside the console. Do not attempt to change or modify the Falcon hardware.
! Conduct normal in-house product safety testing for the system after servicing and before returning
the unit for use on patients.
! Transferring a copy of the Falcon installation program and/or the installation serial number to
people or entities which did not purchase the Falcon system is strictly prohibited.
! Never drop the system or any of its' components. Take special care to prevent the ultrasound
probes and the PPG and temperature sensors, from dropping or knocking on a hard surface in order to
prevent mechanical damage.
! Do not run any other applications on the computer when operating the Falcon. Make sure all other
applications are turned off.
! Never pull on the cables for disconnecting the probes, sensors or other accessories.
! Connect the system only to a personal computer that meets the minimum requirements.
VS0152, rev 1.3 Page
To Next Page
Loading...