Viavi OneExpert DSL - Page 64

Chapter 3 Utilities
OneExpert DSL User's Guide
22052280, Rev. 016 May 202064
4. From the System menu, press the StrataSync icon. The StrataSync settings menu
appears.
5. Specify the following settings:
y System Settings StrataSync Account ID – Enter the account identification
number. Only change this if necessary.
y StrataSync Tech ID/ User ID – Enter the technician/user identification number.
y Server Address – Enter the DNS address for the server. The default address is:
https://stratasync.viavisolutions.com
y Server Port – Enter the server port number. The default port is: 443
6. Press the Start button. As the process runs, the sync state is displayed on the screen.
y Upon synchronization with the StrataSync server, the unit will send to the
server the following information:
– The unit’s serial number.
– The unit’s hardware information (constituent assemblies and their
revision levels).
– The unit’s MAC address.
– The unit’s user settings - name (user/technician) and ID.
– The last calibration date of the copper board (if applicable; this is not
provided for the ONX-580A, which does not have a copper board).
– Software update milestones (includes status and warnings, if applicable)
If the configuration information contained on the server is newer than
that on the unit, the server will be considered to be the most up-to-date.
y The server will then send any files to the unit being synchronized that it
determines are newer than those on the unit.
y The unit will then send any reports, work orders, configuration profiles, XML
results, screen shots, etc. that have been saved on the unit since the last
configuration.
y The server then applies any applicable options to the unit.
y Copy (“clone”) the configuration settings for the base unit, as well as any
company-specific configurations such as custom filters, web bookmarks, and
FTP passwords. This can be used to create a “golden” unit.
NOTE:
If an Option Code was entered as a part of synchronization,
power must be cycled to the unit to complete the process and
initialize the option.