Vibe 7 Series - Channels 5;6 LPF Control; Channels 5;6 LPF Select Switch; Channels 5;6 Phase Shift; High Level Input (Channel 6)

21. CH 5/6 Low Pass Filter (LPF) control
This control is used to set the crossover frequency for channels 5 and 6 when LPF is
selected. The frequency is adjustable between 40Hz and 1000Hz.
22. CH 5/6 Low Pass Filter (LPF) select switch
This switch is used to turn the LPF on or off for channels 5 and 6
23. CH 5/6 Phase shift control
This control is used to alter the output phase of the amplier for channels 5 and 6 and is variable
between 0° and 180°
24. High level input
For connection to any source (headunit) with a low level output. This is your RCA output from the
source.
25. High level input
For connection to the speaker output of your source (head unit). This is to be used if the source
(headunit) does not have a low level output.
26. CH 5/6 Remote level control port
For connection to the supplied remote level control for channels 5 and 6.
27. Speaker terminals
Used to connect speaker cables to the amplier. See the wiring conguration section for more details.
28. Power / protect LED
If the amplier is operating normally, the GREEN LED will illuminate.
If the amplier is in protection mode the RED LED will illuminate.
29. Fuses
Replace with only the same value ATC fuse : 4 x 25A
30. Power terminals
Used to connect DC power to the amplier. See the power connections section for more details
14
CVEN Channel 6 Terminals And Connections