To Next PageTo Next Page
Need help?Do you have a question about the Vibe POWERBOX 60.5 and is the answer not in the manual?
Additional load on vehicle charging system and fuse rating requirements.
Heatsink may become hot; avoid contact with heat-sensitive materials during installation.
Exclusions from warranty coverage, including improper installation and misuse.
Information for obtaining warranty service outside the UK.
Warning about high sound pressure levels causing permanent hearing damage.
Details on connecting power supply, including fuse placement near battery.
Guide for connecting RCA audio sources for channels 1/2.
Guide for connecting speaker-level audio sources for channels 1/2.
Requirements for 4 gauge power and ground cables, including routing and length.
Explanation of the Autosense circuit for automatic amplifier turn-on with high-level input.
Advice on routing RCA cables to avoid interference from other wiring.
Connecting RCA audio sources for channels 1/2 and channel 5.
Connecting speaker-level audio sources for channels 1/2 and 3/4.
Adjusting crossover modes/frequencies and gain for channels 1/2 and 3/4.
Setting LPF, subsonic filter, gain, and remote level for channel 5.
Input mode selection, speaker terminals, fuses, and power/protect LED.
Visual guide for wiring the amplifier for a 5-channel speaker configuration.
Procedure to set amplifier gain to match the source unit, avoiding distortion.
Guidance on setting crossovers for subwoofers, full-range, and passive crossovers.
Contact number and operating hours for UK technical support.
Information on contacting international distributors for support.
General
