PROBLEMS CAUSES SOLUTIONS
The unit will not start The plug is not
connected
Connect the plug
The power is not
switched on
The power is not
switched on
Turn power switch to
on position on the unit
The fuse has blown Replace with a new
fuse
Sounds during
operation
There will be some
normal sounds
generated by the
motor
This is normal
When using the
controller, the unit is
not working
The batteries may be
flat
Replace batteries
The controller is too far
away from the unit
The infrared signal is
effective to 2.5m
Suddenly stops Default working time
is finished
Restart using the
controller if you want
to continue
Not responding to
commands from
controller
Too many commands
may have been sent to
controller and it may
not be able to respond
in time.
Power off and then
start again
Troubleshooting common problems and
solutions
25
To Next Page