Cleaning
Before cleaning, ensure the power switch is turned off and the plug is
removed from the electricity source.
The rubber cover can be cleaned with a wet cloth containing detergent.
Wipe any residue with a clean, damp cloth.
Please do not clean the machine with corrosive detergents such as
benzene or thinner as it may cause fading, corrosion or other damage.
Be careful not to splash liquids into the mechanism of the machine.
Remote control
Only wipe the controller with a dry or slightly damp cloth.
Storage and maintenance
Make sure the power is turned off on the machine and at the wall socket.
Remove power plug from the unit.
Wipe over unit to remove dust and dirt and store away from high
temperature or high humidity
Moving the VibroSlim Radial 3D
There is a wheel under the right hand side of the unit. You will find
handles underneath the unit. Tilt upward from the left hand side and
wheel to the desired place.
If the unit will not be used for longer periods, cover well with a dust proof
cover.
22
To Next Page
Loading...