viceroy 90RF - Page 4

04
Safety
| Safety (continued)
Means for full disconnection
must be incorporated in the xed
wiring in accordance with the
local wiring installation rules
for your country. An all-pole
disconnection switch having a
contact separation of at least
3mm in all poles should be
connected during installation.
When the hood is located above
an appliance, please refer to
dimension A in Step 2 of the
installation diagram for the
minimum distance between
the supporting surface for the
cooking vessels on the hob and
the lowest part of the hood.
Before connecting the hood,
check that the supplied voltage
and frequency match with that
indicated on the appliance
rating plate. Failure to install the
appliance in accordance with
these instructions may result in a
safety hazard. If in doubt, ask for
advice instore or from a qualied
installer.
Consult local regulations
regarding extraction outlets
and ensure these are complied
with. Do not connect the hood
to a ventilation or hot air duct
containing combustion fumes
from burning gas or other fuels.
Conrm that room ventilation
is appropriate with the local
authorities.
The hood may stop working
during an electrostatic discharge
(e.g. lightning). This involves no
risk of damage. Switch o the
electricity supply to the hood and
reconnect after one minute.
This hood can be used by children
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand the
hazards involved. Children shall
not play with the hood. Cleaning
and user maintenance shall not
be made by children without
supervision. Keep the hood and
its supply cord out of the reach of
children less than 8years old.