06
Safety
All installation must be carried out by a
competent person or qualied electrician.
Before connecting to the mains supply ensure
that the mains voltage corresponds to the
voltage on the rating plate.
Direct Connection
The appliance must be connected directly to
the mains using an omnipolar circuit breaker
with a minimum opening of 3mm between
the contacts.
The installer must ensure that the correct
electrical connection has been made and that
it complies with the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and
power cord for damage. If the supply
cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent.
WARNING: This is a Class I
appliance and MUST be
earthed.
This appliance is supplied with a 3 core mains
cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
| Electrical installation
To avoid the risks that are always present
when you use an electrical appliance it is
important that this appliance is installed
correctly and that you read the safety
instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet
for future reference and pass it on to any
future owners. After unpacking the appliance
please check that it is not damaged. If in
doubt, do not use the appliance and contact
Customer Services.
The manufacturer declines all liability for
damage caused to persons and objects
due to incorrect or improper installation
of the appliance. Any permanent electrical
installation must comply with the latest
wiring regulations applicable to your country
and for your own safety a qualied electrician
or contractor should undertake the electrical
installation.
The appliance is supplied from the factory to
use external ducting (not supplied). Should
you wish to use this in recirculation mode
only, please t the correct carbon lter (not
supplied).
FUSE
ON
Double Pole Switched Fused Spur Outlet
USE A 3AMP FUSE
To Next Page
Loading...
