09
| Troubleshooting
Problem Possible cause Solution
Excessive vibration.
The appliance is not installed
properly on the brackets.
Take down the appliance and
check it is properly xed.
The fan blade is damaged.
Switch o the appliance.
Repair to be carried out by
qualied service personnel only.
The fan motor is not xed tightly.
The light is on, but the
fan does not work.
The fan blade is jammed.
The motor is damaged.
Both the light and
motor do not work.
Light bulb blown. Ring the customer helpline at the
end of the Care & maintenance
section to arrange an engineer
visit.
Power connection loose. Check power supply.
Suction performance
reduced.
Speed may be too low. Select a higher speed.
Aluminium lters are dirty. Clean the aluminium lters. (See
Care and maintenance section).
Top vent might be obstructed. Clear any obstruction.
Optional vent kit might be
twisted.
Ensure that the vent kit is tted
according to the manufacturer's
instructions.
The installation may not
comply with the manufacturers
instructions.
The vent hose should be correct
diameter throughout with no
reductions or restriction.
(See installation section).
Works normally but
cooking smells linger.
Carbon lter is not tted in
recirculation mode or is full of
grease.
Fit carbon lter or replace the
carbon lter (See Care and
maintenance section).
This appliance respects laws of the suppression of radio interference. As the Manufacturer has
a policy of continuous product improvement, it reserves the right to adapt and carry out any
modication considered necessary without prior warning.
Safety
To Next Page
Loading...
