1313
ASSEMBLY PROCEDURES
Always place bar cover over bar & chain
when unit is not is use.
Fitting the Bar & Chain
1. Disconnect spark plug 2. Disengage chain brake 3. Remove tensioner nuts
4. Fit bar to unit 5. Fit chain to bar & sprocket 6. Adjust Tension rod
- rod & bar hole to align
7. Fit cover & press firmly
8. Screw on nuts - clockwise
9. Adjust tension - clockwise 10. Tighten nuts - clockwise
11. Perform double checks
Chain direction
Equal spacing
to ensure correct fitment
Chain and bar has very sharp edge's.
Use cut resistant gloves when ever handling
the chain and bar.
To Next Page
Loading...