17
OPERATIONAL INSTRUCTIONS
Chain Lubrication
Use only a high quality chain lubrication oil.
Everytime you use or refuel the chainsaw check the oil levels & add oil accordingly.
Checking the Lubrication before and during cutting
- Position the bar nose over a light background (tree stump) and run the engine at half
throttle.
- Make sure it throws out an increasing trace of oil as shown in the picture below.
Be careful not to allow the tip of the bar to contact any surface as kick back may
occur.
Fuel mixture table
Petrol (unleaded) 2-stroke oil
5 litre 200 ml (Non-Victa Formula V 2-Stroke Oil)
Mixing pr
ocedure: 25 parts petrol to 1 part oil
5 litre 100 ml (Only for Victa Formula V 2 Stroke Oil)
Mixing procedure: 50 parts petrol to 1 part oil
USE Clean fresh "Regular Unleaded Fuel"
Fuel with up to 10% ethanol con be used - 25:1 Fuel/Oil Ratio
Fuel and Oil
NOTE: Fuel Tank capacity is 550mL
NOTE: Oil Tank capacity is 260mL
Never operate the chainsaw without
ensuring adequate lubrication is available.
Operating with no lubrication could cause
catestropohic failure of the unit.
To Next Page
Loading...
Need help?
General
