Victor C5000 - Default Settings

Page 24
STORED VALUE DEFAULT VALUE
Block Area 128. SQ INCH
Block Length 16 INCH
Weight per Volume 1.5 Ton Per CU YD
Board On-center 5-11/16 INCH
Post On-center 8 FEET 0 INCH
Studs On-center 16 INCH
Custom Tile Size 24 SQ INCH
Tile Grout Width 0 INCH
Paint Coverage Area 350. SQ FEET
Unit Cost $0.00
PREFERENCE DEFAULT
Fractional Resolution 1/16
Area Display Standard
Voume Display Standard
Meter Linear Display 0.00
Fractional Mode Standard
Press , then , then keep pressing
to toggle through the main settings.
Press the key to advance within each
sub-setting. Use the key to back up.
Press to exit Preferences.
Conv
Stor
Stor
+
–
On/C
After a Clear All (
Conv
×
), your calculator
will return to the default stored value settings:
Perfom a Full Reset (press
Off
, hold down
×
, press
On/C
), or press the Reset hole
over the
On/C
key to both stored values
and preferences to the default.
Default Settings