• Press to change the day forward and back-
ward.
• Press to vary the programmed starting up
time (the message ON 07:30 will start to flash on
and off).
•
Use the keys to vary the starting up time.
•
Press
to confirm and to go on to the pro-
grammed switching off time (the message OFF
23.30 will start to flash on and off).
•
Use the keys to vary the switching of
f time.
•
Confirm by pressing
.
•
To de-activate the
on/off function on weekly day-off,
press .
The display will read:
(to reinstate, press
)
After the word SUNDA
Y, by pressing again, a
beep will signal that you have come to the following
page.
• The display will read:
This function allows the machine to enter an active
STANDBY status, where it is possible to choose whether
to switch off the machine completely or to keep it at a set
pressure (lower than working pressure).
• Press and the display will read:
Here it is possible to select the XXX mode using the
keys.
The 4 operating modes are:
• OFF: during STANDBY the machine is switched off
and the display reads "";
•
STAN
DBY 0.10 bar: during STANDBY, the machine
maintains a pressure of 0.10 bar and the display (set
to minimum brightness) reads "
";
•
STAN
DBY 0.50 bar: during STANDBY, the machine
maintains a pressure of 0.50 bar and the display (set
to minimum brightness) reads "
";
•
STAN
DBY 0.80 bar: during STANDBY, the machine
maintains a pressure of 0.80 bar and the display (set
to minimum brightness) reads "
".
This type of operation is possible when switching the
machine on/off manually using the key and
when switching the machine on/off automatically using
the ON/OFF programming function.
If the RES key is pressed while the machine is in one
of the standby conditions (0.10 bar, 0.50 bar, 0.80 bar),
the machine switches to OFF. If the key is pressed
again, the machine enters the ON mode.
Press the key to confirm the mode selected
from the display and go back.
Press the key to go back without confirming.
To Next Page
Loading...
Need help?
General
