47
1.1 SAFETY REGULATIONS
1 The present manual is an integral and essential
part of the product and will have to be handed over
to the user. Read carefully the written warnings in the
present manual as they give important suggestions
concerning the safety of installation and set-up, use
and maintenance. Keep this manual in a safe place for
further information.
2 After removing the packaging, check the integral
parts of the machine are intact. If in doubt, do not use
the machine and contact the professionally qualified
personnel. The elements of the packaging must be
kept out of children’s reach as they can be potential
sources of danger and they mustn’t be disposed of in
the environment.
3 Before connecting the machine, make sure that the
data of the plate correspond to those of the electrical
distribution network. The plate is located under the
machine’s base. The installation has to be carried out
in compliance with the regulations of the Country where
the machine is set-up, according to the instructions by
the manufacturer and qualified personnel.
The manufacturer can’t be considered responsible for
possible damage caused by failure in earthing the plant.
For the electrical safety of this machine it is obligatory
to arrange the earthing plant, contact an electrician
with proper and certified technical suitability, to check
the electrical capacity of the plant is adequate to the
maximum power of the machine, stated on the plate.
In particular the electrician will have to make sure that
the section of the plants’ cables is suitable to the power
absorbed by the machine.
The use of adaptors, multi-sockets and extensions is
forbidden. If their use is necessary, it is compulsory to
call a licensed electrician.
4 When installing the device, it is necessary to use
the parts and materials supplied with the device itself.
Should it be necessary to use other parts, the installa-
tion engineer needs to check their suitability for use in
contact with water for human consumption.
4 This machine must be installed according to the
applicable federal, state, and local standards (codes) in
force with regard to plumbing systems including back-
flow prevention devices.
For this reason, the plumbing connections must be car-
ried out by a qualified technician.
❺ The device needs to be supplied with water that
is suitable for human consumption and compliant with
the regulations in force in the place of installation.
The installation engineer needs confirmation from the
owner/manager of the system that the water complies
with the requirements and standards stated above.
1. GeneRALRemARKSOnTHecOnSiGnmenT
To Next Page
Loading...
Need help?
General
