❻ This machine will have to be used only for the
purpose described in this manual.
The manufacturer can’t be considered responsible
for possible damage caused by improper, wrong, or
unreasonable uses.
WA
Before using the machine read carefully and completely
the instruction manual, safety regulations and the
machine tuning/ directions.
❼
This appliance is not suitable for use by children or
persons with reduced physical, sensory or mental capabili-
ties, or by persons with a lack of experience or knowledge,
unless supervised or given instructions.
➑ The maximum and minimum storage temperatures
must fall within a range of [-5, +50]°C.
❽ The operating temperature must be within the
range of [+5, +35]°C.
❾ At the end of installation, the device is switched on
and taken to rated operating conditions, leaving it in a
state in which it is “ready for operation”.
The device is then switched off and the whole hydraulic
circuit is bled of the first lot of water in order to remove
any initial impurities.
The device is then refilled and taken to rated operating
conditions.
After reaching the “ready for operation” condition, the
following dispensing operations are carried out:
- 100% of the coffee circuit through the coffee dispenser
(for more than one dispenser, this is divided equally);
- 100% of the hot water circuit through the water dis-
penser (for more than one dispenser, this is divided
equally);
- opening of each steam outlet for 1 minute.
At the end of installation, it is good practice to draw up
a report of the operations.
❿
The use of any electrical device must comply with
fundamental regulations. In particular:
•
do not touch the machine with wet hands or feet;
• do not use the machine barefoot;
•
do not use extensions in places used as a bath or
shower;
• do not pull the supply cable, to disconnect the
machine from the supplying net;
• do not leave the machine exposed to atmospheric
agents (rain, sun, etc);
•
do n
ot allow the machine to be used by children or
by non-authorised personnel that haven’t read and
understood this manual.
•
Duri
ng installation, the mains power system needs
to be equipped with a disconnector switch to cut off
each phase.
⓫ The authorised technician has to, before carrying
out any maintenance operation, unplug the socket after
having switched off the machine switch.
⓫For the cleaning operations bring the machine
to energetic state , that is to say
and keep exclu-
sively to what is stated in the present manual.
To Next Page
Loading...
Need help?
General
