8.5
CLEANING THE UNIT
WITH THE AID OF
THE BLIND FILTER
The machine is set to wash the delivery group
with an automatic cleaning cycle and specific
powder detergent. It is advisable to wash the
machine at least once a day.
8.6 CLEANING FILTERS
AND FILTER-
HOLDERS
Place two teaspoons of special cleanser in half
a litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.
8. CLEANING
Stop the machine with the three main switches,
moving them to the position 0.
The machine must be set to “O” power (switch
off and disconnector open) before any cleaning
operations are performed.
Do not use solvents, chlorine-based prod-
ucts or abrasives.
Cleaning the work area: remove the
worktop, lifting it up from the front and sliding it
out. Remove the water collection dish under-
neath and clean everything with hot water and
cleansers.
Cleaning the bottom: To clean all the
chromium-plated areas, use a soft, damp cloth.
8.1 STOP
8.2 CLEANING THE
OUTSIDE OF THE
MACHINE
Fig. 22
WARNING
It is not possible to clean the machine using
water jets or standing it in water
WARNING
8.3 CHANGING THE
WATER IN THE
BOILER
To always ensure the best quality water, the
water in the boiler must be changed daily whilst
being used. Repeatedly press the hot water key
to remove at least a third of the total litres con-
tained in the boiler.
8.4 CLEANING THE
STAINLESS COFFEE-
HOLDERS
The stainless steel showers are located under
the delivery units.
NOTE: To clean proceed as follows:
7XUQWKHVFUHZSODFHGLQWKHFHQWUHRI
the coffee-holder.
6OLGHWKHFRIIHHKROGHURXWDQGFKHFNWKDW
its holes are not obstructed but clean.
,I REVWUXFWHG FOHDQ DV GHVFULEHG
(Paragraph “CLEANING FILTERS
AND FILTER-HOLDERS”)
We recommend cleaning the coffee-
holder once a week.
Fig. 23
To Next Page
Loading...
Need help?
General
