36
ENGLISH
must not be carried out by children
unless supervised.
The appliance must not be installed
where it may be used water jets.
The device can be installed only in plac-
es where the use and maintenance is
limited to qualified personnel.
The operating temperature must be
within the range of [+5, +30]°C.
At the end of installation, the device is
switched on and taken to rated operat-
ing conditions, leaving it in a state in
which it is “ready for operation”.
After reaching the “ready for operation”
condition, the following dispensing
operations are carried out:
RIWKHFRIIHHFLUFXLWWKURXJK
the coffee dispenser (for more
than one dispenser, this is divided
equally);
2SHQWKHVWHDPRXWOHWIRUPLQXWH
At the end of installation, it is good prac-
tice to draw up a report of the operations.
WARNING
Before using the machine, read this
manual in its entirety or, at the very
least, read the safety and set up instruc-
tions.
There are some basic rules for the use
of any electrical appliance.
In particular:
1HYHU WRXFK WKH XQLW ZLWK ZHW
hands or feet;
1HYHUXVHWKHXQLWZLWKEDUHIHHW
1HYHU XVH H[WHQVLRQ FRUGV LQ
areas equipped with baths or
showers;
1HYHU SXOO RQ WKH SRZHU VXSSO\
cord to unplug the unit;
1HYHU OHDYH WKH XQLW H[SRVHG WR
atmospheric agents (rain, direct
sunlight, etc..);
1HYHU OHW FKLOGUHQ XQDXWKRUL]HG
personnel or anyone who has not
read this manual operate the unit.
Before performing any sort of mainte-
nance, the authorized technician must turn
off the unit and unplug it from the mains.
Before cleaning the unit set it in a state
of "0" energy: that is, "MACHINE
SWITCHED OFF AND UNPLUGGED".
Follow the instructions given in this
manual carefully.
Refer to chapters 6 and 7 for periodical
cleaning and maintenance.
OK
In case of breakdown or poor function,
turn off the unit. Never tamper with the
unit. Contact only professionally quali-
fied personnel.
Only the manufacturer or an authorized
service center can make repairs and
only using original spare parts.
Non compliance with the above can
compromise machine safety.
On installation, the qualified electrician
must fit a circuit breaker switch as fore-
seen by the safety norms in force that
has a contact open distance that permits
the complete disconnection under con-
ditions of overload category III.
To prevent dangerous overheating, it is
advisable to fully extend the power sup-
ply cord.
Never block the intake and/or heat dissi-
pation grills, in particular those for the
cup warmer.
To Next Page
Loading...
Need help?
General
