53
ENGLISH
5. PROGRAMMING
5.1 KEY
① LCD Display.
② RESET key: to confirm and return
to the previous step.
③
CURSORS
key
: to scroll the menu and
④ to increase and
decrease values.
⑤ ENTER key: to access the menu.
ACCESS TO MENÙ:
7RHQWHUWKHPDFKLQHPHQXVHOHFWZLWKWKHŸ
źNH\VWKH
Menu
button and confirm with the
ENTER key.
The display of the menu can be set to two
modes:
USER (password enabled);
TECHNICIAN (password disabled).
The machine has the password off by default,
with the ability to access the full menu.
If a password was set, accessing the menu you
will be asked to enter a password:
5.2 VISUALIZATION
(USER Mode)
LIST OF DISPLAY FUNCTIONS (USER Mode)
AUTO. CLEAN. CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
The machine will read:
1.21 bar
21 MarchSunday 14:45
AUTO.CLEAN.CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
Ź
4
3
1
2
5
1.21 bar
21 MarchSunday 14:45
INSERT PASSWORD
- - - -
To enter USER mode, press ENTER without
changing any value.
To enter TECHNICIAN Mode, enter the pass-
ZRUG DFWLQJ ZLWK WKH Ÿ ź NH\V DQG SUHVV
ENTER.
AUTOMATIC CLEANING CYCLE:
7KHGLVSOD\ZLOOVKRZ
1.21 bar
21 MarchSunday 14:45
AUTO.CLEAN.CYCLE
DOSES
DELIVERY COUNT
TOTAL
MACHINE TOTAL
CLEANING COUNTER
Ź
3UHVVENTER and the display will read:
1.21 bar
21 MarchSunday 14:45
AUTO.CLEAN.CYCLE
SELECT
The key in each unit will begin to flash
on and off. Insert the blind filter into the filter-
holder, add half a dose of detergent and
attach the filter-holder into the unit where
you intend to carry out the automatic clean-
ing cycle. Carrying out a cleaning cycle in
more than one unit at a time is possible.
3UHVVWKH
key to start the unit automatic
cleaning cycle. The display will read:
Fig. 21