REINITIALIZING THE CHRONOGRAPH HANDS
Following an incorrect activate, violent impact or exposure to a
strong magnetic field, one or the other of the chronograph counter
hands may fail to revert to its original position (zero). To reinitialize
the hands, proceed as follows:
Zero Reset of the Minute Counter Hand
• Pull out the crown to position 2.
•Press pusher B briefly until the hand reverts to the
original position (on 60).
Zero Reset of the Seconds Counter Hand
• Pull out the crown to position 3.
•Press pusher A briefly until the hand reverts to the
original position (on 60).
33
•Press pusher B to continue timing. The chronograph will con-
tinue its measurement by reverting the 1/10th hand to zero
and “flying back” to the elapsed time.
•Press pusher B again to read the second split time.
• Repeat this procedure until the action to be timed has been
completed.
•Press pusher A to stop timing.
NOTE: Timing will be indicated within 1/10th of a sec-
ond on appropriate sub-dial.
• Once the timing operation has been stopped, press
pusher B briefly until the hands revert to the original
position. The chronograph and totalizer hands will
be reset to zero.
32
To Next Page
Loading...
