Victron energy MultiPlus 24/5000/120-100 User Manual (English)

Other manuals for Victron energy MultiPlus 24/5000/120-100

Questions and Answers:

S
Scott GoodmanAug 10, 2025
Why is the alarm LED flashing on my Victron energy MultiPlus 24/5000/120-100?
- P
  petersonbrittanyAug 10, 2025
  If the alarm LED is flashing on your Victron Energy Inverter, it could be due to several reasons: * Low DC input voltage: Charge the battery or check the battery connections. * High ambient temperature: Place the inverter in a cool, well-ventilated room or reduce the load. * Overload: Reduce the load on the inverter. * Excessive voltage ripple: Check the battery cables and terminals, and increase battery capacity if needed. * Low battery voltage and excessive load: Charge the batteries, reduce the load, install higher capacity batteries, and use shorter/thicker battery cables.
K
Kelsey WilcoxAug 17, 2025
What to do if the battery is not being charged fully by Victron energy MultiPlus 24/5000/120-100 Inverter?
- S
  Sally FrancisAug 17, 2025
  If your Victron Energy Inverter's battery is not being charged fully, it could be due to several reasons: * Incorrect charging current: Set the charging current between 0.1 and 0.2 times the battery capacity. * Defective battery connection: Check the battery terminals. * Incorrect absorption voltage: Adjust the absorption voltage to the correct value. * Incorrect float voltage: Adjust the float voltage to the correct value. * Defective internal DC fuse: This indicates the inverter is damaged.
J
Judith MeyerAug 25, 2025
Why is the battery overcharged when using Victron energy MultiPlus 24/5000/120-100 Inverter?
- M
  Margaret WilsonAug 26, 2025
  If your Victron Energy Inverter's battery is overcharged, it could be due to: * Incorrect absorption voltage: Adjust the absorption voltage to the correct value. * Incorrect float voltage: Adjust the float voltage to the correct value. * Defective battery: Replace the battery. * Battery too small: Reduce the charging current or use a battery with a higher capacity. * Battery too hot: Connect a temperature sensor.
B
Billy HowardAug 31, 2025
Why does the battery charge current drop to 0 when the absorption voltage is reached on my Victron energy MultiPlus 24/5000/120-100?
- E
  Elizabeth RothAug 31, 2025
  If the battery charge current drops to 0 when the absorption voltage is reached on your Victron Energy Inverter, it could be due to: * Battery overtemperature (above 50°C): Allow the battery to cool down, place it in a cool environment, and check for shorted cells. * Faulty battery temperature sensor: Unplug the battery temperature sensor, reset the Multi by switching it off for 4 seconds and then on again. If charging returns to normal, the sensor is faulty and needs replacement.

Victron energy MultiPlus 24/5000/120-100 Specifications

General

Model	MultiPlus 24/5000/120-100
Input Voltage	24 VDC
Efficiency	94%
AC Input Voltage Range	187-265 VAC
Maximum Charge Current	120 A
Output Voltage	230 VAC
Maximum Efficiency	95%
Transfer Time	20 ms
Battery Voltage	24 V
Output Power (Continuous)	5000VA / 4000W
Output Power (Surge)	10000 VA
Peak Power	10000VA / 8000W
Protection	Overload, short circuit, over temperature