What to do if the 'overload' LED flashes on my Victron Energy Inverter?
If the 'overload' LED is flashing on your Victron Energy Inverter, it means the load connected to the inverter is higher than its nominal capacity. To resolve this, disconnect a portion of the load.
Why is the 'low batt.' LED flashing on my Victron Energy Inverter?
If the 'low batt.' LED is flashing on your Victron Energy Inverter, it indicates that the battery voltage is low. You should recharge the batteries or check the battery connections to fix this issue.
What does it mean when the 'overload' LED is on solid on a Victron energy Phoenix 12/225 Inverter?
If the 'overload' LED is illuminated on your Victron Energy Inverter, it means the inverter has switched off because the load is too high. You should disconnect part of the load to resolve this.
What does it mean when the 'low batt.' LED is on solid on a Victron energy Phoenix 12/225?
If the 'low batt.' LED is illuminated on your Victron Energy Inverter, it means that the inverter switched off because the battery voltage was too low. Recharge the batteries or check the battery connections.
Why is the 'temp.' LED flashing on my Victron Energy Inverter?
If the 'temp.' LED is flashing on your Victron Energy Inverter, it indicates that the ambient temperature is high, the temperature of internal components is high, or the load is too high. Place the inverter in a cool, well-ventilated area or disconnect part of the load to resolve this.
What does it mean when the 'temp.' LED is on solid on a Victron Energy Inverter?
If the 'temp.' LED is illuminated on your Victron Energy Inverter, it means the inverter has switched off due to a high ambient or component temperature, or because the load is too high. To fix this, place the inverter in a cool, well-ventilated place or disconnect part of the load.
Why are 'low batt.' and 'overload' LEDs flashing together on my Victron Energy Inverter?
If both the 'low batt.' and 'overload' LEDs are flashing on your Victron Energy Inverter, it indicates a low battery voltage and a load that is too high, or that the ripple voltage at the input exceeds 10%. To solve this, try the following: * Recharge the batteries. * Disconnect part of the load. * Place a ripple suppressor or use batteries with a higher capacity. * Mount shorter or thicker battery cables.
What does it mean when the 'low batt.' and 'overload' LEDs are solid on my Victron Energy Inverter?
If the 'low batt.' and 'overload' LEDs are illuminated on your Victron Energy Inverter, the inverter switched off due to a ripple voltage at the input that was too high. You can place a ripple suppressor and/or batteries with a higher capacity. Also, mount shorter and/or thicker battery cables and reset the inverter (switch OFF and ON again).
General| Model | Phoenix 12/225 |
|---|---|
| Input Voltage | 12 V |
| Quiescent Current | 0.5 A |
| Output Voltage | 230 V |
| Output Frequency | 50 Hz |
| Protection | Overload, over temperature |
To Next Page