To Next PageTo Next PageWhat to do if the Victron energy Phoenix Multi inverter overload LED flashes?
If the overload LED is flashing, it means the load on the inverter is higher than the nominal load. You should reduce the load.
What to do if the Victron energy Phoenix Multi Industrial Equipment inverter overload LED is on?
If the overload LED is illuminated, the inverter has cut out because of excessive load. You should reduce the load.
What to do if the “low battery” LED flashes on my Victron energy Industrial Equipment?
If the low battery LED is flashing, this indicates that the battery voltage is low. You should charge the battery or check the battery connections.
What to do if the Victron energy Phoenix Multi inverter fails to operate when switched on?
If the inverter isn't turning on, the battery voltage might be too high or too low. Make sure the battery voltage is within the correct range.
What to do if the Victron energy Phoenix Multi battery is not being charged fully?
If your battery isn't fully charging, consider these possibilities: 1. The charging current is incorrect: Set the charging current at between 0.1 and 0.2x battery capacity. 2. There's a defective battery connection: Check the battery terminals. 3. The absorption voltage is set incorrectly: Adjust the absorption voltage to the correct value. 4. The float voltage is set incorrectly: Adjust the float voltage to the correct value. 5. The DC fuse is defective: Replace the DC fuse.
Why is the “temperature” LED flashing or on for my Victron energy Industrial Equipment?
If the temperature LED is flashing or on, it means either the ambient temperature is too high, or the load is excessive. Try placing the inverter in a cool and well-ventilated room, or reduce the load.
What to do if the Victron energy Industrial Equipment battery is overcharged?
If the battery is overcharged, it may be due to: 1. Incorrect absorption voltage: Adjust the absorption voltage to the correct value. 2. Incorrect float voltage: Adjust the float voltage to the correct value. 3. Defective battery: Replace the battery. 4. Battery too small: Reduce the charging current or use a battery with a higher capacity. 5. Battery too hot: Connect a temperature sensor.
What to do if the Victron energy Phoenix Multi inverter cuts out because the battery voltage is too low?
If the low battery LED is on, the inverter cuts out because the battery voltage is too low. Charge the battery or check the battery connections.
What does it mean if the “low battery” and “overload” LEDs flash alternately on my Victron energy Industrial Equipment?
If the low battery and overload LEDs are flashing alternately, it indicates low battery voltage and excessive load. You should charge the batteries, reduce the load, or install batteries with a higher capacity. Also, consider using shorter and/or thicker battery cables.
What does it mean if the “low battery” and “overload” LEDs flash simultaneously on my Victron energy Industrial Equipment?
If the low battery and overload LEDs are flashing simultaneously, it means the voltage ripple on the DC input exceeds 1.25Vrms. Check the battery cables and terminals, and check the battery capacity, increasing it if necessary.
General| Input Voltage | 230V AC |
|---|---|
| Output Voltage | 230V AC |
| Output Frequency | 50/60 Hz |
| Battery Voltage | 12V, 24V, 48V |
| DC Connection | Screw terminals |
| Operating Temperature | -20°C to 60°C |
| Protection | Overload, short circuit, over temperature |
| Remote Control | VE.Bus |
| Communication Port | VE.Bus |
| Charger | Yes |
| Transfer Switch | Automatic |
| Transfer Time | 20ms |
