To Next PageTo Next PageWhat does it mean if the “low battery” and “overload” LEDs are on on my Victron energy Phoenix Multi?
If the low battery and overload LEDs are on, the inverter has cut out due to excessive voltage ripple on the DC input. Install batteries with a higher capacity and use shorter and/or thicker battery cables. Then, reset the inverter by switching it off and on again.
Why does the battery charge current drop to 0 when the absorption voltage is reached in my Victron energy Phoenix Multi?
The battery charge current may drop to 0 when the absorption voltage is reached due to two possible reasons: 1. Battery over temperature (> 50°C): Allow battery to cool down, place battery in a cool environment and check for shorted cells. 2. Battery temperature sensor faulty: Unplug battery temperature sensor from the Multi. Reset the Multi by switching it off, then wait for 4 seconds and switch it on again. If the Multi now charges normally, the battery temperature sensor is faulty and needs to be replaced.
General| Input Voltage | 230 VAC (196-265 VAC) |
|---|---|
| Output Voltage | 230VAC |
| Output Frequency | 50Hz or 60Hz |
| Continuous Output Power | 3000 VA or 5000 VA (depending on model) |
| Battery Voltage | 12V, 24V, or 48V |
| Transfer Time | 20ms typical |
| Protection | Output short circuit |
| Humidity | 95%, non-condensing |
| Model | Phoenix Multi |
