4-2 How to Turn on the Printer Rev AA
Videojet 1710 Operator Manual
Standby Mode
The Videojet 1710 printer uses pigmented inks which should be mixed on a
regular basis. Thus, the printer performs ‘ink mixing’ at set intervals whenever the
jet is not turned on. For ink mixing to take place, the power supply must be
applied to the printer at all times.
Note: If power is removed from the printer, a buzzer will beep notifying the user
that the power has been removed from the printer. Please reconnect the power as
soon as possible.
Standby Mode Function
During printer start up, if the ‘on/standby’ switch is in ‘out’ position, it initializes
and enters into Standby Mode. In standby mode, all the unrequired functions of
EHT, fans, gutter pump, air pump are stopped and only low voltage power is left
on the printer boards.
Note: To turn on the printer normally, press the switch to ‘in’ position. This
completes a full reboot of the printer.
Standby Mode During Ink Mixing
When the printer needs to run an ink mixing sequence, the power is restored to the
required functions like the fans, mixer and the printer undergoes a ‘wake up’
sequence. The LCD screen displays the ink mixing prompt and provides 30
seconds to the operator to postpone mix or let it run. After the ink mix is complete,
the LCD screen, pumps and fans are powered down after 30 seconds.
To Next Page
Loading...