Rev AA Turn off the Printer 4-31
Videojet 1710 Operator Manual
Turn off the Printer
EQUIPMENT DAMAGE. Turn off the printer after the jet shutdown cycle
is complete. The failure to follow this caution can cause additional
maintenance.
EQUIPMENT DAMAGE. Do not start and stop the printer many times.
When you stop the printer, the printer uses the make-up fluid to flush the
system. If you start and stop the printer many times, the printer uses large
amount of make-up fluid. The increased use of make up fluid can cause a
Ink Core Level High error and low ink viscosity. To prevent this problem,
quick start and stop must be used.
Press the on/standby switch to put the printer in standby mode.
Note: The on/standby switch is used to put the printer to standby mode. Switching
the power switch to ‘off’ will put the printer into ‘Standby mode’. Standby mode
allows the ink core mix sequence to run as programmed and return to standby
mode when complete. To enable standby mode, power must remain to the printer.
PERSONAL INJURY. While in the standby mode, power remains in the
printer at a low voltage. To carry out any internal maintenance work,
remove the power to the printer by removing the plug from the mains power
supply.
To Next Page
Loading...