5-16 Menu Description Rev AA
Videojet 1710 Operator Manual
Photocell Levels To allow the use of both High and Low activating
photocells this command enables the photocell
trigger level to be set to high or low.
Shaft Encoder Source -The different sources of the shaft encoder signal
are: Internal, External and Auto Encoder.
Auto Print on Jet You can enable the machine start printing when
the ink jet has started.
Note: A message must be available.
Auto Print on
Select
Enables the machine to be set up so that it will
initiate printing as soon as a message has been
selected subject to the ink jet having started.
Serial Port
Configuration
You can configure the serial port.
Configure Menu Commands Function
Table 5-9: Configure Menu and Commands (Continued)
To Next Page
Loading...