Creating and Printing Messages
6-12
Creating a Reversed, Inverted, or Bold Character
Introduction
The procedures in this section show you how to create characters
that are reversed or inverted, or make the character bolder within a
message.
NOTE:To apply reverse, invert, or bold characteristics to an
entire message, refer to
Apply Reverse, Invert, and
Bold to Entire Messages
on page 6-16.
You can create a character that is a combination of these features.
For example, you can create a character that is both reversed and
inverted at the same time, or you can create a character that is
reversed and bold at the same time.
NOTE:Reverse message, invert message, and bold message
settings override individual character settings. Refer
to
Apply Reverse, Invert, and Bold to Entire Messages
on page 6-19 for further information.
Procedures in this
Section
The procedures in this section explain how to do the following:
•
Reverse a Character ...................................turn to page 6-13
•
Invert a Character.......................................turn to page 6-14
•
Change the Character
Multi–Stroke (Bold)...................................turn to page 6-15
To Next Page