VIDEOJET Excel 2000 Series - Applying Reverse, Invert, and Bold to Entire Messages; Procedures for Message-Level Formatting

Creating and Printing Messages
6-16
Applying Reverse, Invert and Bold to Entire Messages
Introduction
The procedures in this section show you how to create a reversed,
inverted, or bold message, how to reverse each character
(individually) within the message, and how to adjust the message
height and width of a message.
NOTE: To create a reversed, inverted, or bold (individual)
character, refer to
Creating a Reversed, Inverted, or
Bold Character
on page 6-12.
You can create a message that is a combination of these features.
For example, you can create a message that is both reversed and
inverted at the same time, or you can create a message that is
reversed and bold at the same time, etc.
Procedures in this
Section
The procedures in this section explain how to do the following:
• Reverse a Message.....................................turn to page 6-17
• Invert a Message ........................................turn to page 6-18
• Reverse All Characters...............................turn to page 6-19
• Change the Message
Multi–stroke (Bold)....................................turn to page 6-20
Refer to Figure 6-10 for an illustration of the frames used in this
section.
OFF
REVERSE
MESSAGE
CLEAR
MESSAGE
VIEW
PRINT
PRINT
MESSAGE
01
EDIT
xxxx
PRINT
MATRIX
xxxx
CHAR.
SIZE
CHAR.
SET-UP
02
EDIT
RECALL
MESSAGE
STORE
MESSAGE
VIEW
STORE
PRINT
MESSAGE
03
EDIT
SERVICE
PRINTER
SYSTEM
SET-UP
PRINT
SET-UP
04
EDIT
MESSAGE
HEIGHT
MESSAGE
WIDTH
0
PRINT
DELAY
01
PRINT
PROD.
RESET
0000000
PRODUCT
COUNT
0000000
PRINT
COUNT
0
PRINT
RESET
02
PRINT
1
MULTI-
STROKE
OFF
INVERT
MESSAGE
OFF
REVERSE
ALL CH.
03
PRINT
Figure 6-10. Accessing Frame <03 PRINT>