• Move the cursor to the FIXED field. Press [CHG] to cycle through the
three choices: Fixed, Relative In, and Relative Out.
• Move the cursor to the TIME/OFFSET field. If you selected FIXED, press
[CHG], then enter the time code for the event. If you selected RELATIVE
IN or RELATIVE OUT, press [CHG], then enter the offset amount from
the IN or OUT time of the related Scene or Source Event.
NOTE: If you selected RELATIVE IN or RELATIVE OUT, a sign field (±)
precedes the offset. In most cases, you will use a (+) for a Relative In; in all
cases you should use a (-) for a Relative Out.
Tuning GPI Events
If your GPI Events always start a little earlier or later than where you marked
them, add an offset value to the GPI configuration parameter. The offsets are
measured in 1/8 frame increments, so if the events start one frame late, add an
offset of -0008. If they start one second late, add an offset of -0240 (NTSC=8x30)
or -0200 (PAL=8x25).
To Next Page
Loading...