129
Parameter Code Delivered condition Commission-
ing
Maintenance/
service
Temperature range input 0...10 V, cooling
mode
700E Do not adjust.
External extension 7010 0
System components for external change-
over
7011 0
Operating status for external changeover 7012 2
Duration of external changeover 7013 8 h
Effect of external demand on heat pump/
heating circuits
7014 4
Effect of ext. blocking on heat pump/heating
circuits
7015 4
Vitocom 100 (type GSM/GSM2 only) 7017 0
Temperature range input 0..10V 7018 1000 (≙ 10 V)
Priority external demand 7019 0
Effect of external blocking on pumps/
compressor
701A 0
Common flow temperature sensor system 701B 0
Operating status after message A9, C9 701C 0
Effect of OM changeover to ventilation 701F 3
Type of assembly kit 7044 0
Holiday program effect 7050 384
Compressor
Parameter Code Delivered condition Commission-
ing
Maintenance/
service
Enable compressor 5000 1
Evaporator temperature for defrost end 5010 Automatically preset
Enable use of compressor stage 5012 15
Output compressor stage 5030 Rated heating output
according to type
plate
Commissioning/service reports
Control parameter report (cont.)
5831412
Appendix
To Next Page
