To Next PageTo Next Page
Need help?Do you have a question about the Viessmann Vitodens 200-W 19 WB2B Series and is the answer not in the manual?
General| Type | Condensing Boiler |
|---|---|
| Water Pressure | Max. 3 bar |
| Electrical Connection | 230 V / 50 Hz |
| Efficiency | Up to 98% |
| Heat Exchanger | Inox-Radial stainless steel |
| Fuel Type | Natural Gas/LPG |
| Max. Flow Temperature | 85°C |
| Control | Vitotronic control unit |
Ensures installation, service, and maintenance are performed by a qualified professional.
Highlights risks of carbon monoxide from improper installation or maintenance and requires detectors.
Stresses the necessity of a proper venting system to prevent carbon monoxide poisoning.
Stresses the installer's responsibility to familiarize the owner with system operation and safety.
Details codes, electrical wiring standards, and safety device compliance for installation.
Specifies conditions for the mechanical room, including temperature and air quality.
Outlines recommended minimum service clearances around the boiler for installation.
Provides an overview of piping connections and required fittings, emphasizing sealant use.
Details the process for installing the wall mounting bracket and mounting the boiler.
Covers gas piping requirements, including sizing, shutoff valves, and pressure testing.
Describes how to connect the boiler to the heating system, including flushing and pressure limits.
Details making the domestic hot water connections, including tank sensor integration.
Details the condensate drain setup, including trap requirements and material specifications.
Guides on installing safety devices like the pressure relief valve and drain valve.
Outlines the hydrostatic pressure testing procedure to ensure system integrity.
Presents pressure drop data for the primary circuit and guidelines for sizing circulation systems.
Illustrates a direct-connected heating circuit system layout with the boiler.
Shows a system with DHW storage, a heating circuit with mixing valve, and system separation.
Describes boiler integration with refrigeration systems and airflow control for cooling cycles.
Covers the overall electrical connection strategy for the boiler and its accessories.
Details the mounting and connection of the Power/Pump module to the boiler.
Details electrical connections for the boiler's main control board.
Explains how to connect various accessories like sensors and communication modules.
Guides on how to properly insert and secure the programming unit into the control.
Presents detailed specifications, dimensions, and performance data for the boiler models.
Offers a detailed schematic of all electrical connections for the entire system.
Crucial safety warnings and instructions to follow before the initial start-up of the appliance.
Step-by-step guide for safely lighting and operating the boiler.
Illustrates the control logic and circuit pathways of the boiler's operation.
