23
Menu selection Explanation
nie senden (Never
transmit)
The value of this datapoint is never transmitted to the EIB
system.
bei jeder Änderung sen-
den (transmit after every
change)
The value of this datapoint is transmitted to the EIB system
following any change.
5 % bis 25 % (5 % to
25 %)
The value of this datapoint is transmitted to the EIB system
in the case of a deviation according to the set percent-
age.
Error bit central fault message
Example with ETS3
Any fault on a component of the heating
system can trigger the transmission of a
"Fehlerbit Sammelstörung" error bit cen-
tral fault message to an appropriate cen-
tral fault message facility. However, this
requires the fault message to be actually
captured by the Vitotronic control unit.
You can select the transmission inter-
val.
Zykluszeit (Cycle time)
Menu for the selection of the transmis-
sion interval to be assigned to the central
fault message error bit.
Commissioning
Parameters in ETS
(cont.)
5592 880 GB
Service
To Next Page
Loading...
