8
The appliance is intended solely for installation and
operation in sealed unvented heating systems, with
due attention paid to the associated installation, serv-
ice and operating instructions. The appliance is inten-
ded exclusively for steam generation and for heating
water in accordance with EN 12953 and AGFW data-
sheet FW510 (VdTÜV datasheet TCh 1466).
Commercial or industrial use for a purpose other than
steam generation or the heating of water shall be
deemed inappropriate.
All other use is deemed inappropriate. Any resulting
losses are excluded from the manufacturer's liability.
Any usage beyond this must be approved by the man-
ufacturer in each individual case.
Intended use presupposes that a permanent installa-
tion in conjunction with permissible components
designed for this purpose has been carried out.
Intended use also includes adherence to maintenance
and inspection intervals.
Systems with operating temperatures > 110 °C
Category IV boiler systems compliant with Pressure Equipment Directive
Requirements for commissioning
■
System installation has official approval.
■
The system has been checked by an expert author-
ity.
■
Commissioning of the control system is carried out
by a qualified organisation.
Requirements for operators
Only qualified personnel may operate, supervise and
service the system.
Requirements for operation without supervision
■
Boiler system is equipped in accordance with EN
12953, Part 6.
■
The system has received official approval for opera-
tion.
Checking system operation
Scope checks should be determined in accordance
with EN 12953-6
Danger
The surfaces of steam boilers and hot water
boilers and other areas of the system are poten-
tially hot. Risk of injury!
Always wear protection when touching the rele-
vant areas during operation.
Information
Intended use
5837984
Information
To Next Page
