14
Selecting the Input Source
To select the input sources connected to the display:
1. Press INPUT on the remote control.
2. Press
or to select the desired input source.
3. To conrm the selection, press OK.
Enter
Using the Lock Control
With LOCK CONTROL, you can block input source.
Password is required to access the LOCK CONTROL menu. The default is “0000”.
Changing Password
To change a new password:
1. Press MENU to display the OSD main menu.
2. Press
or to select LOCK menu, then press OK
to enter the menu.
3. Enter the password.
4. Press or to select Change Password, then
press to enter its submenu.
5. Enter the old password.
6. Enter your new password.
7. Enter your new password again to Conrm.
The screen will return to the LOCK CONTROL
menu. This indicates the password has been
changed.
8. Press EXIT to exit the menu.
To Next Page
Loading...
Need help?
General