13
Operation
Turning the Display On and Off
Press
on the remote control.
You can also use the
key on the front side of the
panel.
* If there is no input signal within 10 minutes, the
display will be turned off automatically.
Adjusting the Volume
Press VOL +/- to adjust volume.
To turn off the volume, press MUTE.
To restore volume, press MUTE again, or press
VOL +/- directly.
Viewing the Displayed Information
To display the current information of the display:
Press INFO, and the current state will be displayed
on the screen. (It shows all or some of the information
about Input, Resolution, etc., depending on the input
source)
* The illustration shows an example of the INFO
screen in an HDMI source.
To Next Page
Loading...
