EasyManuals Logo

ViewSonic EP4320-2 User Manual

ViewSonic EP4320-2
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
40
10. Troubleshooting
If, after reading these operating instructions, you have additional questions related to the use of your display,
please call the services center in your local area.
Before calling service, please check the symptoms and follow suggested solutions.
Remote Control
Problem Possible Solutions
Remote control does not operate  The batteries could be weak. Replace the batteries.
 Check the orientation of the batteries.
 Make sure the power cord is plugged in.
Video and Audio
Problem Possible Solutions
No picture (screen not lit), No
sound
 Make sure the power cord is plugged in.
 Press POWER on the display or on the remote control.
Dark, poor or no picture (Screen
lit), good sound
 Select a proper picture mode.
 Adjust the brightness in the video setting.
No color/dark picture/abnormal
color
 Adjust the color saturation in the video setting.
Dotted lines or stripes  Move the display away from noise sources such as cars, neon
signs, or hair dryers.
Good picture, no sound  The sound may be muted. Press MUTE again to cancel.
Audio noise  Communication problems may occur if infrared communication
equipment (e.g., infrared cordless headphones) is used near the
display. Move the infrared communication equipment away from the
display until the noise is eliminated.
General
Problem Possible Solutions
Some items can’t be accessed  If a setting option appears in gray, this indicates that the settings
option is unavailable in current input mode.
Remote control command is not
HႇHFWLQVRPHFDVHV
 During the timing of USB device detection (i.e. when the display is
turned on with USB device connected, or when you plug in USB
device during display working), the display may not act by remote
control buttons in such case. Wait some time, then it is OK.
Control buttons do not operate  Disconnect the power cord and wait for a few seconds. Then re-plug
the power cord and turn on the unit again.
POWER button responds slowly
after power is connected.
 When you push POWER SWITCH to power on the display, in about
3 seconds the POWER button starts to respond after pressed.
Note:
,I\RXUSUREOHPLVQRWVROYHGWXUQ\RXUXQLWRႇDQGWKHQRQDJDLQ
Cautions:
Never attempt to repair a defective display yourself.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ViewSonic EP4320-2 and is the answer not in the manual?

ViewSonic EP4320-2 Specifications

General IconGeneral
BrandViewSonic
ModelEP4320-2
CategoryDigital Signage
LanguageEnglish

Related product manuals