ViewSonic ID2456 - Initial Setup

13
Inial Setup

Wall Mounng
Refer to the table below for the standard dimensions for wall mount kits.
NOTE: 

local dealer.
Maximum
Loading
Hole paern
(W x H)
Interface Pad
(W x H x D)
Pad Hole
Screw Specicaon
& Quanty
14 kg 100 x 100 mm 115 x 115 x 2.6 mm Ø 5 mm
M4 x 10 mm
4 pieces
NOTE: Wall mount kits are sold separately.
1. 
2. 
3. Ensure the adjustable stand is fully retracted.
4. 
monitor. Then secure it with four (4) screws (M4 x 10 mm).
Type-C
Out
HDMI
HDMI
USB 3.0
5V/2A
100 mm
100 mm
5. 
monitor onto the wall.