ViewSonic ID2456 - Page 19

19
• VGA Connecon
1. Connect a VGA cable from your computer to the VGA port on the monitor.
2. Connect the USB Type A to Type B cable from your computer to the monitor to
enable touch controls.
Type-C
Out
HDMI
HDMI
USB 3.0
5V/2A
VGA
VGA

• 
cable is removed and plugged in again, or the computer resumes from
Sleep Mode.
• 
• 
touch the screen, do the following:
1. Open: Control Panel > Hardware and Sound >Tablet PC Sengs
2. Select Calibraon.
3. 

following:
1. Open: Control Panel > Hardware and Sound > Tablet PC Sengs
2. Select Setup.
3. Select Touch Input.
4. 