1. Connect the power cord to the power adapter.
2. Connect the power adapter to the DC IN jack at
the rear of the projector.
3. Plug the power cord into a power outlet.
NOTE: When installing the projector, incorporate a readily accessible disconnect
device in the fixed wiring, or connect the power plug to an easily accessible outlet
near the unit. If a fault should occur during operation of the projector, use the
disconnect device to switch off the power supply, or disconnect the power plug.
Connecting to External Devices
Connect one end of an HDMI cable to the HDMI port of your video device. Then connect the other
end of the cable to the HDMI 1/2 port of your projector.
LS740HD - ViewSonic Projectors https://manuals.viewsonic.com/LS740HD_Full_Guide
11 von 54 29.02.2024, 12:40
To Next Page
Loading...
