ViewSonic LS920WU - Connecting to Video Sources; HDMI Connection; S-Video Connection; Composite Video Connection

24
Connecting to Video Sources
HDMI Connection
Connect one end of an HDMI cable to the HDMI port of your video device. Then
connect the other end of the cable to the HDMI 1 or HDMI 2 port of your projector.
S-Video Connection
Connect one end of an S-Video cable to the S-Video port of your video device. Then
connect the other end of the cable to the S-VIDEO port of your projector.
Composite Video Connection
Connect one end of a Video cable to the Video port of your video device. Then
connect the other end of the cable to the VIDEO port of your projector.
Connecting to Computer Sources
VGA Connection
Connect one end of a VGA cable to the VGA port of your computer. Then connect
the other end of the cable to the COMPUTER IN port of your projector.
NOTE: Some notebooks do not turn on their external displays automacally when
connected to a projector. You may have to adjust your notebook’s projecon
sengs.
VGA Out Connection
After establishing the VGA Connection, connect one end of a VGA cable to the VGA
port of your monitor. Then connect the other end of the cable to the MONITOR
OUT port of your projector.
Connecting to Audio
The projector is equipped with speakers, however, you can also connect external
speakers to the AUDIO OUT port of the projector.
NOTE: The audio output is controlled by the projector’s Volume and Mute sengs.
Connecting to HDBaseT Device
HDBaseT is a technology to transmit image signal through a LAN cable. Connect
Cat5e/Cat6 cable from HDBaseT TX Box for HDBaseT signal received.
Video Signal - Connect it to HDBaseT output equipment (Such as high-definition TV
source, Blu-ray Player....etc).