EasyManua.ls Logo

ViewSonic LS920WU - Safety Precautions

ViewSonic LS920WU
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Safety Precauons
Please read the following Safety Precautions before you start using the projector.
Keep this user guide in a safe place for later reference.
Read all warnings and follow all instrucons.
Allow at least 20“ (50 cm) clearance around the projector to ensure proper
venlaon.
Place the projector in a well-venlated area. Do not place anything on the
projector that prevents heat dissipaon.
Do not place the projector on an uneven or unstable surface. The projector may
fall over, causing personal injury or projector malfuncon.
Do not use if the projector is lted at an angle of more than 10° degrees le or
right, nor at an angle of more than 15° degrees forwards or backwards.
Do not look straight at the projector lens during operaon. The intense light
beam may damage your eyes.
Do not block the projecon lens with any objects when the projector is under
operaon as this could cause objects to become heated and deformed or even
cause a re.
Do not aempt to disassemble the projector. There are dangerous high voltages
inside which may cause death if you should come into contact with live parts.
When moving the projector, be careful not to drop or bump the projector on
anything.
Do not place any heavy objects on the projector or connecon cables.
Do not stand the projector on end vercally. Doing so may cause the projector to
fall over, causing personal injury or projector malfuncon.
Avoid exposing the projector to direct sunlight or other sources of sustained
heat. Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including ampliers) that may increase the temperature
of the projector to dangerous levels.
Do not place liquids near or on the projector. Liquids spilled into the projector
may cause it to fail. If the projector does become wet, disconnect it from the
power supply and call your local service center to have the projector serviced.
When the projector is under operaon, you may sense some heated air and odor
from its venlaon grill. It is a normal operaon and not a defect.

Table of Contents

Related product manuals