ViewSonic LX700-4K - Setup Menu

46
Setup Menu
Select Exit Enter
Setup
Projection
Power Settings
Security
HDMI CEC
Test Pattern
Options
Reset
i
Menu Descripon
Projecon
Select the preferred projecon locaon: Desk Front, Desk
Rear, Ceiling Front, or Ceiling Rear.
Power Sengs
Direct Power On
Automacally power on the projector when DC power
is supplied, without pressing the Power buon on the
projector or the remote control.
Signal Power On
Automacally power on the projector when a signal is
detected, without pressing the Power buon on the
projector or on the remote control.
Auto Power O
A countdown mer will start when there is no signal being
sent to the projector. The projector will automacally power
o when the countdown has nished (in minutes).
Security
Security
Enable or disable a password prompt before using the
projector.
NOTE: The default password is: 1234
Change Password
Set or modify the password.
NOTE: Please follow the OSD message to input the
current password rst, then enter a new
password (security code). Conrm the new
password by entering the new password again.