14
Connecting a computer or monitor
Connecting a computer
1. Take the supplied VGA cable and connect one end to the D-Sub output socket of the
computer.
2. Connect the other end of the VGA cable to the Computer 1 or Computer 2 signal
input socket on the projector.
3. If you wish to use the remote mouse control function, take a USB cable and connect
the larger end to the USB port of the computer, and smaller end to the Mini USB
socket on the projector. See "Using the remote PgUp/PgDn function" on page 7 for
details.
Many notebooks do not turn on their external video ports when connected to a projector.
Usually a key combo like FN + F3 or CRT/LCD key turns the external display on/off. Locate a
function key labeled CRT/LCD or a function key with a monitor symbol on the notebook. Press
FN and the labeled function key simultaneously. Refer to your notebook's documentation to
find your notebook's key combination.
Connecting a monitor
If you want to view your presentation close-up on a monitor as well as on the screen, you
can connect the Monitor Out signal output socket on the projector to an external monitor
with a VGA cable following the instructions below:
(for Component signal)
(for selected models)
Computer
Out
VGA cable
Monitor
or
VGA to DVI-A cable
Audio
in
Audio cable
Computer
Audio cable
A/V device
or
Video
connector
Video cable
A/V device
To Next Page
Loading...
